CB Black Box Programmable Timing Control Module

CB Performance Black Box Programmable Timing Control Module

The Black Box Programmable Timing Control Module connects directly to your distributor and existing coil offering a fully programmable 21 x 21 spark table, good up to 10,000 rpm. The Black Box incorporates a 5 Bar MAP Sensor, allowing boosted timing control over 40 psi.

The Black Box also has an internal low and high end rev limiter and is housed in an attractive billet aluminum housing. The Black Box is incredibly small for its performance output, measuring only 3 5/16" L x 2 3/16" wide.

The Black Box will connect to ignition points, aftermarket ignition modules such as Compu-fire and Pertronix, MSD distributors, CB Performance Magnaspark 2 Ready-to-run and Magnetic Trigger distributors.

Most aftermarket ignition boxes can also be used such as MSD 6A, 6AL, 7AL, Summit and Mallory.

Will not work with a Compu-Fire DIS-IX Module.

The Black Box uses an internal coil driver that will support up to 8 cylinders. V8 ignitions using old school distributors can now be affordable converted into modern high powered programmable ignitions at a fraction of the cost. Need fuel economy? The Black Box will allow up to 45 degrees of ignition advance. CB has seen as high as 20% improved fuel economy when the Black Box was installed and properly tuned.

Distributor must be locked out with no internal advance.

Please scroll down to the bottom of this page to download a copy of the installation manual.